Flashing Sign Systems Installation Guide

Flashing Sign Systems Installation Guide




This guide is intended to guide a qualified technician through the process of installing a complete Flashing Sign System.
NOTE
Many aspects of this guide may or may not apply to the hardware selected for you project.

Introduction - System Discussion


Introduction - Post Layout and Design


Introduction - Device Roles (Controller and Collaborators)


Solar Engine Models Installation


Fiberglass Enclosure Models Installation


"S" Box Models Installation


LED Sign Ring Retrofit Installation


Chevron Installation


RRFB Installation


Radar Detector Installation


Pedestrian Push Button Installation

TC Remote Accessory and Water Presence Detector Installation


Solar Engine Electrical Connections (see wiring diagrams at bottom for more details)


AC Electrical Connections (see wiring diagrams at bottom for more details)




Wiring Diagrams


Note
Wiring diagrams are provided as a general introduction, local advising from a licensed electrician should be sought out to provide compliant installation

Radar activated with a Solar Engine type controller or collaborator and flashing sign


Radar activated with a AC Engine type controller or collaborator and flashing sign



Push 2 Cross system with a Solar Engine type controller or collaborator, RRFBs, and a flashing sign (super-cross system)



Push 2 Cross system with a Solar Engine type controller or collaborator, Guardian Wave audible push Button, RRFBs, and a flashing sign (super-cross system)



Push 2 Cross system with a Solar Engine type controller or collaborator, Polara INX audible push Button, RRFBs, and a flashing sign (super-cross system)



High Water Detection system with a Solar Engine type controller or collaborator, water presence detector, and a flashing sign



Icy Road Detection system with a Solar Engine type controller or collaborator, icy conditions detector, and a flashing sign














    • Related Articles

    • Flashing Sign Systems Troubleshooting Guide

      Trafficalm Flashing sign system are used in variety of ways. Push 2 Cross, Curve Warning Systems, Stop Rings, Conflict Intersections, Highwater Warning, or School Zone Beacon Flashers are just a few ways the systems can be setup to operate. ...

    • Flashing Sign Systems Quickstart Guide

      System Overview TraffiCalm Flashing Sign systems are available in multiple configurations to suit diverse project requirements. Typically, systems include a Flash Controller (also known as a solar engine), a Sign Ring, and an input device such as a ...

    • Troubleshooting and Technical Guide for TraffiCalm Flashing Sign Systems

      Flashing Sign Systems Troubleshooting - This article is intended to provide you with guided troubleshooting tactics for resolving issues with your flashing sign system. This system attributes to a wide variety of applications, so providing exhaustive ...

    • Flashing Sign System - All Flash Setup Guide

      Guide to Setting Up an All Flash System Using TC Connect Overview "All Flash" is the term within TC Connect for configuring any flashing LED signs that are not part of other intelligent solution systems, such as Push 2 Cross, Chevron, or High Water. ...

    • Flashing Sign and LED Ring System Setup Guide

      Flashing Sign and LED Ring System Installation Guide This guide provides comprehensive instructions for installing a basic flashing LED sign system. This system, typically applied to stop signs, can also be used to enhance the visibility of a variety ...