How to Connect to a TraffiCalm Flashing Sign System via WiFi
How to Connect to a TraffiCalm Flashing Sign System via WiFi
Overview
Connecting or "pairing" your device to a TraffiCalm Flashing Sign System via WiFi is essential for system setup and management. This guide provides step-by-step instructions to ensure a seamless connection and setup process. ONLY controllers will have Wi-Fi.
Warning: Power Cycle to Enable WiFi
- Disconnect Power: From the electronics tray within the controller cabinet.
- Reconnect Power: 10 seconds after disconnecting.
- Wait: 1-3 minutes for WiFi to reactivate.
Wi-Fi enabled
- A blue LED will flash on the control board every 10 seconds when Wi-Fi is available to connect to.
Steps to Connect via WiFi
Power On the Controller:
- Turn on the controller to activate WiFi for 2 hours. If WiFi shuts down, reboot the controller.
Connect to WiFi:
- On your device, select the TraffiCalm_Setup_xxxxx network from WiFi settings.
- Use the password Tr@ffiCalm to connect.
Note: If the unit was previously configured, the WiFi network name may appear as "Push2Cross," "Chevron," or "Beacon."
Access Setup Portal:
- Open any web browser and go to Setup.Trafficalm.com.
- Follow the prompts to complete the setup process.
Conclusion
Following these steps will enable you to successfully connect and configure your TraffiCalm Flashing Sign System via WiFi. This connectivity is crucial for managing and maintaining the functionality of your traffic management solutions.
Related Articles
Flashing Sign Systems Troubleshooting Guide
Trafficalm Flashing sign system are used in variety of ways. Push 2 Cross, Curve Warning Systems, Stop Rings, Conflict Intersections, Highwater Warning, or School Zone Beacon Flashers are just a few ways the systems can be setup to operate. ...Flashing Sign System - All Flash Setup Guide
Guide to Setting Up an All Flash System Using TC Connect Overview "All Flash" is the term within TC Connect for configuring any flashing LED signs that are not part of other intelligent solution systems, such as Push 2 Cross, Chevron, or High Water. ...Flashing Sign System - All Flash Scheduling
Setting Up Scheduling for All Flash Configuration Overview "All Flash" is the term within TC Connect for configuring any flashing LED signs that are not part of other intelligent solution systems, such as Push 2 Cross, Chevron, or High Water. This ...Flashing Sign Systems Quickstart Guide
System Overview TraffiCalm Flashing Sign systems are available in multiple configurations to suit diverse project requirements. Typically, systems include a Flash Controller (also known as a solar engine), a Sign Ring, and an input device such as a ...How to Factory Reset Your Flashing Sign System
Overview Quickly reset your flashing sign systems to default settings using this simple guide. Ideal for resolving setup issues or starting fresh. Connecting to Your Sign Download the Software: Open the following link in your web browser: Download TC ...