Replacing a Chevron Curve Warning Sign

Applicable Models

• M75-R2430-BA1L: 24 x 30" Flasher Ring, Chevron Left - Amber
• M75-R1824-BA1L: 18 x 24" Flasher Ring, Chevron Left - Amber
• M75-R1824-BA1R: 18 x 24" Flasher Ring, Chevron Right - Amber
• M75-R2430-BA1R: 24 x 30" Flasher Ring, Chevron Right - Amber
• M75-R3036-BA1L: 30 x 36" Flasher Ring, Chevron Left - Amber
• M75-R3036-BA1R: 30 x 36" Flasher Ring, Chevron Right - Amber
• M75-R3648-BA1L: 36 x 48" Flasher Ring, Chevron Left - Amber
• M75-R3648-BA1R: 36 x 48" Flasher Ring, Chevron Right - Amber
  

Step-by-Step Instructions

Step 1: Physical Replacement

1. Remove the Damaged Sign and Flasher Ring

   • Carefully remove the damaged Chevron sign and its associated flashing LED ring from the post.
   • Ensure all debris and damaged components are cleared from the area.

2. Install the New Sign and Flasher Ring

   • Position the new Chevron sign and flashing LED ring on the post.
   • Use the supplied hardware to secure the new sign and flasher ring in place.
   • Ensure the sign is securely mounted and the flasher ring is properly aligned.

Step 2: Connecting to the System

1. Access the System Interface

   • Connect your laptop to the system's Wi-Fi network.
   • Open a web browser and navigate to setup.trafficalm.com.

2. Login to TC Speed Connect

   • Use the following credentials to log in:
     
     • Username: admin
     • Password: Tr@ffiCalm
   • If you have not received these credentials or are experiencing login issues, please contact customer support for assistance.

Step 3: Configuring the New Collaborator ID

1. Access the Configuration Page

   • Once logged in, navigate to the setup page and select the 'Chevron System Setup' option.

2. Remove the Old Collaborator ID

   • Identify the collaborator ID of the damaged Chevron sign (e.g., Chevron 2).
   • Remove this collaborator ID from the system configuration.

3. Add the New Collaborator ID

   • Enter the new collaborator ID for the replacement Chevron sign.
   • Save the configuration to update the system with the new collaborator ID.

Step 4: System Settings and Final Checks

1. Brightness Settings

   • Review and confirm the brightness settings. The default settings are typically sufficient for most installations.
   • Click 'Save and Continue' to proceed.

2. Flasher Settings

   • Set the minimum water level required to flash (default is '1').
   • Configure the flash rate to 60 flashes per minute.
   • Use unison output for standard flash rings.

3. Collaborator Setup (if applicable)

   • If using a collaborator, add its ID in the system settings.
   • Configure the collaborator to flash in unison with the main controller when the sensor is triggered.

Step 5: Testing and Verification

1. System Verification
   
   • Ensure that the new Chevron sign and flasher ring are properly integrated into the existing curve warning sequence.
   • Check that the system operates as expected, with all signs flashing in the correct sequence.